DSPIAE - Departure Tool Combo Set - TC-S01

Departure” Tool Combo Set TC-S01 DSPIAE

Plate Pickup
Basic version single edge cutter

Due to the height difference design of the single-edged scissors, the centre nozzle needs to be trimmed with a pen knife or file after cutting.

When cutting the runner, it is normal that the runner and blunt surface have slight indentation
Engraving pen repair parts
Daybreak Carving Pen

For nozzles that cannot be handled by the scissors at one time, use the dawn engraving pen for secondary trimming
Please use the engraving pen in a standardized manner, and do not use it for dangerous operations to avoid injury.
Please make sure to install the nib in place to avoid the nib falling off during use.

After use, please cover the pen cap to prevent accidental drop from causing injury or product damage. The nib of the engraving pen is a consumable item, please replace the blade in time after long-term use, so as not to affect the cutting effect.

Part grinding
Semi-Rigid Grinding Stick (General Grinding)
Carbon fibre grinding plate + durable adhesive sandpaper (flat grinding)
Sponge gauze (surface grinding)
Glass polishing file (transparent parts grinding)

Fine operation
Straight tweezers | Bend tweezers to pick up water stickers or small parts for fine operation
Parts seepage
Phoenix Feather Liner Pen
Submerge the seepage liquid over this calibre

Dip in an appropriate amount of seepage liquid and do not exceed the calibre.

Gently scrape off excess line seepage on the mouth of the bottle. After determining the position of the seepage line, press lightly with the tip of the pen, and the line seepage liquid will flow into the groove by itself. After the line seepage liquid is evenly covered, lift the line penetration pen, and wait for it to dry to complete the line penetration.

(It is recommended to use DSPIAE T-08 enamel paint thinner to wipe off excess line seepage)
Line pen maintenance
Just wipe it clean after use (it is recommended to use DSPIAE T-03 coating tool cleaning fluid)
Wrong assembly and disassembly
push opener
Putting away the cutter head in time after use can effectively avoid the risk of dropping and damaging the cutter head. Please handle with caution as this product contains sharp parts. Please store it in time after use.

Package included:
TC-S01 Starter Tool Set

• 1 x Tool Storage Box
• 1 x Basic Single Edge Cutter
• 1 x push opener
• 1 x Daybreak Sculptor
•  20 x Replacement hobby knife blades
• 1 x Durable Sponge Sandpaper #400 (3mm)
• 1 x Durable Sponge Sandpaper #800 (3mm)
• 1 x Durable Sponge Sandpaper #1200 (3mm)
• 1 x Heavy Duty Adhesive Backed Sandpaper #400
• 1 x Heavy Duty Adhesive Backed Sandpaper #800
• 1 x Durable Adhesive Backed Sandpaper #1000
• 1 x Durable Adhesive Backed Sandpaper #1200
• 1 x Durable Adhesive Backed Sandpaper #1500
• 2 x Carbon Fibre Sanding Plates
• 1 x Semi-rigid sanding stick #600
• 1 x Semi-rigid sanding stick #800
• 1 x Semi-rigid sanding stick #1200
• 1 x Glass Polishing File
• 1 x straight tweezers
• 1 x Angled Tweezers
• 1 x scissors